Example ::: *5 (MASTER CODE) 02 (USER ID) 3456 (TYPE IN NEW CODE) #.
Here is an example of how to add a code to your system.To delete a code follow the steps you would to enter or change a code and put all stars in.If you have more to put in them just follow the steps outlined, if not then press the # key. When the code has been entered the keypad will ask you for another user ID.Once you have typed in the user ID then you can put in the code that you want, 4 digits. Well, ipFob is a mobile connection to your Honeywell, Ademco, DSC PowerSeries, and GE NetworX alarm control systems.If you have several codes then you might want to keep a spread sheet of user ID and codes. Start with user ID number 02 and count up from there. This is a number that the panel uses to know where the code is stored. Next it will ask you for a 2 digit ID number.The NX-4 can also be programmed to report an alarm after two or more trips on the same zone. Resetting Smoke Detectors To Reset smoke detectors: Press and hold until keypad beeps. It will ask you for your code, this is where you type in the MASTER CODE. During the time between trips, the NX-4 can be programmed to sound the keypad and/or the siren.On the keypad press the * key and then the number 5.You can do it on any keypad that you have, but one that has an LCD display is preferred over and LED type. First off have your MASTER CODE in hand, go to any keypad with an LCD display.IF YOU DO NOT KNOW OR HAVE PURCHASED A HOUSE OR A USED SYSTEM YOU WILL HAVE TO CALL AN ALARM COMPANY TO COME AND CONNECT A PC TO THE PANEL IN ORDER TO DO ANYTHING WITH THE CODE. THERE IS NO WAY AROUND THIS AS THIS IS A SECURITY FEATURE BUILT INTO THE SYSTEM. VERY IMPORT ANTÂ YOU MUST KNOW YOUR CODE (MASTER CODE) OR YOU WILL NOT BE ABLE TO CHANGE, ADD, DELETE, OR UPDATE THE USER CODES IN YOUR SYSTEM.